Is Tree Removal Dangerous Work?

Is Tree Removal Dangerous Work?

Last Updated: October 30, 2026

Quick Summary

Tree removal is dangerous work, with falls from height the leading cause of death in the trade. A study of 1,285 worker deaths found 44% were trimming or pruning when fatally injured, and power line contact, falling limbs and chainsaw kickback add serious risk.

  • Falls are the leading killer, often from ladders set wrong or failed tie-in points.
  • A branch touching a live line can energize the entire tree.
  • Crews mark overhead lines and structures before any equipment arrives.
  • Saw operators clear two escape paths at roughly 45 degrees before each back cut.
  • Hire a professional whenever a tree is near a structure, power line or person.

Table of Contents

Tree Removal Hazards That Put Workers at Real Risk

Tree removal is dangerous work, and the numbers show it. Tree removal carries serious hazards, and planning every removal around them is what keeps workers and property safe.

Falls From Trees and Ladders

Falls are the leading killer in this trade. A study of 1,285 worker deaths between 1992 and 2007 found that 44% of the workers were trimming or pruning when fatally injured, according to research on work-related fatalities in tree care. Most of those deaths started with a fall from height.

The usual causes:

  • A ladder set at the wrong angle or on soft ground
  • A limb that gives way under a climber’s weight
  • A harness tie-in point that fails
  • Slippery bark after rain or frost

Overhead Power Lines and Electrocution

Power lines are the hazard homeowners underestimate most. OSHA’s inspection guidance for tree care and removal operations treats falls and contact with energized lines as core dangers of the job. A branch that touches a live line can energize the whole tree.

For a closer look at working near live conductors, read our guide to professional tree removal near powerlines.

Falling Limbs, Uncontrolled Tree Movement, and Cutting Equipment

A tree does not always fall where you expect. Limbs drop without warning, trunks barber-chair, and root plates tear loose. Chainsaws and wood chippers add a second layer of risk: kickback, chain contact, and entanglement at the feed chute.

How Dangerous Is Tree Work? What the Fatality Data Shows

Tree work is widely recognized as a hazardous occupation.

The pattern holds across studies. NIOSH and state Fatality Assessment and Control Evaluation programs reviewed 95 investigated landscaping and tree-care fatalities, catalogued in tree trimming and fall cleanup injury research. The common threads: falls, struck-by injuries, and electrical contact.

Here is what that means in plain terms:

Hazard Typical Scenario Why It Kills
Falls Climber or ladder work at height Head and spinal trauma
Electrocution Limb contacts a live line Cardiac arrest
Struck-by Falling limb or trunk section Crushing injury
Cutting Chainsaw kickback or contact Severe blood loss

Tree Removal Safety Precautions That Actually Prevent Injuries

Real injury prevention comes down to planning before the saw starts. A written hazard assessment, a marked work area, and a clear chain of command stop most incidents before they begin. Here is the general sequence a trained crew follows on a removal, and what a homeowner should expect to see on their property.

1. Site walk and utility check. Before any equipment rolls in, the crew walks the property and marks every overhead line, service drop, fence, septic field, and structure within falling distance. Calling for a utility locate is a sensible precaution even when the work looks clear of buried lines, because root plates and equipment can disturb what is underground.

2. Written hazard assessment. The supervisor records the tree’s lean, defects, species, diameter, and the drop zone, then picks the removal method: straight fell, sectional rigging, or crane-assisted. This is the stage where crane-assisted removal is considered, because a crane changes the drop zone, the rigging loads, and the number of people who need to be under the tree.

3. Exclusion zone and work-zone controls. The drop zone is fenced or coned off, and one person is assigned to keep bystanders, pets, and vehicles out. On a residential lot this often means closing a driveway or a sidewalk. If a worker or bystander is injured, the exclusion zone is also what keeps a second person from walking into the same hazard.

4. Escape route before every cut. The saw operator identifies two clear paths away from the stump at roughly 45 degrees from the fall line, cleared of tripping hazards, before the back cut starts. This is the single habit most associated with surviving a barber-chair or a tree that shifts off the hinge.

5. Rigging and controlled lowering. Ropes, slings, blocks, and a friction device let the crew lower limbs instead of dropping them. Sectional removals near a roof or a line depend on this step, because the load on the rigging point has to be calculated, not guessed.

6. Communication and emergency plan. One qualified person directs the work, and everyone on site knows the signal to stop. Crews should also know the address, the nearest access point for an ambulance, and who is calling 911 if something goes wrong.

Get a FREE Quote Today! →

Watch Out
A homeowner should never stand inside the exclusion zone to “watch” or give directions. Falling limbs and uncontrolled tree movement do not announce themselves, and the drop zone is the most dangerous place on the property during a removal.

The California tree work safety guide goes further: qualified tree workers should direct trimming, removal, and repair, and any hazard found on site should be corrected immediately. That last point matters for homeowners, if a crew finds a defect mid-job, the safe move is to stop and reassess, not to push through the original plan.

Arborist Safety Equipment: What Trained Crews Rely On

Proper gear is the difference between a close call and a funeral. Trained crews rely on a full set of personal protective equipment, climbing systems, and rigging hardware, checked before every job.

Arborist inspecting climbing gear and ropes before a tree removal job with a bucket truck in the background
Arborist inspecting climbing gear and ropes before a tree removal job with a bucket truck in the background

The core kit:

  • Head and eye protection: hard hat, safety glasses, face shield
  • Fall protection: climbing harness, lanyard, friction device
  • Cut protection: chainsaw chaps and cut-resistant gloves
  • Hearing protection: ear muffs or plugs
  • Rigging: ropes, slings, blocks, and carabiners rated for the load

Risk by Tree and Site Condition: Dead, Leaning, and Storm-Damaged Trees

Some trees are far riskier than others, and the difference is not just the tree, it is the tree plus the site. A healthy oak in an open yard is a very different job from the same oak leaning over a roof with a service drop running through the canopy. The following red flags and conditions can help a homeowner judge why one removal is routine and another is not.

Red flags to watch for:

  • Cracks or splits in the trunk, especially vertical seams or seams that open and close
  • Mushrooms or conks at the base, or a hollow sound when the trunk is tapped
  • A lean that appeared after a storm, or a lean that is increasing
  • Hangers: broken limbs caught in the canopy
  • Exposed roots, soft soil, or a root plate that is lifting
  • Included bark where two trunks meet, a common failure point

How risk changes by condition:

Condition What Makes It Riskier What Changes for the Crew
Dead tree Wood loses strength and predictability; limbs can drop without warning Often climbed or rigged in sections rather than felled, and sometimes handled with a crane to keep workers out of the drop zone
Leaning tree The lean may indicate root failure or a defect, and the fall direction is harder to control Requires a planned fall line, wedges, or rigging; a lean toward a structure usually rules out a straight fell
Storm-damaged tree Split trunks, sprung limbs under tension, and hangers that can release when cut Tension and compression wood has to be read before every cut; some limbs are lowered, not cut free
Power-line-adjacent tree Contact can energize the tree, the equipment, and the ground Utility coordination and qualified line-clearance work; this is not a homeowner or general-landscaping job
Tree over a structure The drop zone includes a roof, deck, or fence Sectional rigging or crane-assisted removal to control every piece
Tree on a slope or soft soil Equipment access and footing are compromised; the tree may move unexpectedly Different equipment, more rigging, and a wider exclusion zone
Key Takeaway
The practical rule: risk goes up when the tree is already failing, when the drop zone contains something you cannot replace, or when the site limits how the crew can control the tree. Any two of those together is a job for a professional crew, not a weekend project.

If you spot these signs, read our guide to the signs of hazardous trees. For storm damage, our emergency tree removal services cover urgent cases, and A professional assessment can help tell a tree that can be saved from one that has to come down. When a tree is dead, split, or leaning over a structure, crane-assisted removal is often considered as a way to take the weight off the tree and keep the crew out of the drop zone.

When to Hire a Tree Removal Professional (and How to Verify One)

Hire a professional whenever a tree is near a structure, a power line, or a person, or when it is dead, leaning, or storm-damaged. The DIY line is simple: if a mistake could hit your house or a line, it is not a homeowner job.

How to verify a crew before you sign:

  • Ask for proof of ISA certification and check it
  • Confirm the company carries insurance
  • Ask who supervises the job on site
  • Get the scope of work in writing
  • Ask how they handle rigging near structures

A Touch of Class Tree Service Inc. is led by ISA Certified Arborists and Licensed Qualified Supervisors. Learn what that credential means in our guide to the benefits of an ISA certified arborist.

Get a Free Quote From a Certified Crew

The safest removal is the one handled by a crew that plans for the worst. If you have a hazardous tree on your property, do not wait for the next storm to decide.

A Touch of Class Tree Service Inc. brings over 30 years of experience, fully insured crews, and state-of-the-art equipment to every job. We focus on local safety, arborist expertise, and protecting your property.

Get started with A Touch of Class Tree Service Inc. and request tree removal in Colorado with a free quote from a certified crew.

Frequently Asked Questions

How dangerous is tree service work?

It is one of the more hazardous occupations in the country. Falls, electrocution from overhead power lines, falling limbs, and chainsaw or chipper contact are the leading causes, which is why trained crews treat every tree removal as a controlled operation.

What are the biggest risks involved in tree removal?

The main tree removal hazards are falls from height, contact with overhead power lines, being struck by falling limbs or an uncontrolled trunk, and cutting injuries from chainsaws and chippers. Dead, storm-damaged, and leaning trees add unpredictability because limbs can drop without warning. OSHA inspection guidance specifically flags fall-from-elevation hazards in tree care and removal, and safety guides recommend that qualified tree workers direct operations and correct unsafe practices immediately.

Why should homeowners avoid removing large trees themselves?

A homeowner without training, rigging experience, or arborist safety equipment faces the same hazards professionals do, without the controls that make the work survivable. Tree felling direction is hard to predict when a tree is dead or leaning, and a limb near a power line can turn a weekend project into an electrocution risk. Professional crews use harnesses, ropes, exclusion zones, and site preparation to manage those risks, and they carry insurance that covers property damage if something goes wrong.

How do professional arborists make tree removal safer?

Certified arborists start with a hazard assessment of the tree and site, then plan the cut, the rigging, and the drop zone before anyone climbs. Crews set up an exclusion zone with fencing and clear marking, wear personal protective equipment, and use specialized equipment matched to the tree’s condition. Safety guidance from state regulators calls for qualified tree workers to direct trimming and removal operations and for identified hazards to be corrected immediately, which is the standard a reputable crew follows on every job.